Edison Ortiz Sat, 01/12/2008 - 15:40

Please post the output from typing:

show ip int brief | ex una

and

show spanning-tree

where are you pinging from and where are you pinging to ?

__

Edison.

Edison Ortiz Sat, 01/12/2008 - 15:58

Bridge group 50 is executing the ieee compatible Spanning Tree protocol

Bridge Identifier has priority 32768, address 001b.2adf.6ba8

Configured hello time 2, max age 20, forward delay 15

We are the root of the spanning tree

Topology change flag not set, detected flag not set

Number of topology changes 1 last change occurred 03:33:03 ago

from Vlan1

Times: hold 1, topology change 35, notification 2

hello 2, max age 20, forward delay 15

Timers: hello 0, topology change 0, notification 0, aging 300

Port 2 (FastEthernet0/0) of Bridge group 50 is down

Port path cost 19, Port priority 128, Port Identifier 128.2.

Designated root has priority 32768, address 001b.2adf.6ba8

Designated bridge has priority 32768, address 001b.2adf.6ba8

Designated port id is 128.2, designated path cost 0

Timers: message age 0, forward delay 0, hold 0

Number of transitions to forwarding state: 0

BPDU: sent 0, received 0

Port 3 (FastEthernet0/1) of Bridge group 50 is down

Port path cost 19, Port priority 128, Port Identifier 128.3.

Designated root has priority 32768, address 001b.2adf.6ba8

Designated bridge has priority 32768, address 001b.2adf.6ba8

Designated port id is 128.3, designated path cost 0

Timers: message age 0, forward delay 0, hold 0

Number of transitions to forwarding state: 0

BPDU: sent 0, received 0

___

What's connected on those ports ?

If you want to ping interface BVI 50, one of these ports need to be up.

avionics Sat, 01/12/2008 - 16:05

at the present nothing is connected. i have a device connected to fa1/7 but am unable to ping that device. the device i am trying to ping is 10.10.1.1 shouldnt i be able to do this?

avionics Sat, 01/12/2008 - 16:06

sorry im all confused the device i am trying to ping is connected to fa1/0.

Edison Ortiz Sat, 01/12/2008 - 18:56

That's Vlan 100. This router doesn't have any IP on Vlan 100 so it needs a device to route from Vlan 50 (which is the only IP from the switch) to Vlan 100.

Actions

This Discussion