01-13-2008 07:08 AM - edited 03-05-2019 08:26 PM
we need to limit the traffic passing throught one of ports of our 3750 switch, for example, the port speed limit to 1M, how to implement that? thanks in advance
01-13-2008 08:01 AM
Hi,
The interface configuration command is: srr-queue bandwidth limit.
I hope this helps.
Best regards.
Massimiliano.
01-13-2008 10:23 AM
The command recommended by Massimiliano will definitely give you what you want, however it's best to understand all other QoS components in the 3750, so check out the full document on the subject at:
HTH,
__
Edison.
01-20-2008 07:25 PM
thanks for both of you, what if i try to limit the traffic below 1M? say, 128K?
01-21-2008 09:59 AM
On a L3 or L2 switchport ?
__
Edison.
01-21-2008 10:39 PM
layer3
01-22-2008 06:22 AM
You need rate-limit
rate-limit output 128000 14000 14000 conform-action transmit exceed-action drop
01-22-2008 04:26 PM
thanks, what about the layer 2 switch solution?
01-22-2008 04:31 PM
01-23-2008 07:36 AM
i think this can only limit the traffic to 1M because the minimum parameter is 10 percent, my question is: how to configure lower than 1M, say 128K?
01-24-2008 04:46 PM
You can't with Layer2 switchports.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: