cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
282
Views
0
Helpful
1
Replies

incoming caller id on T-1 CAS

rvincent
Level 1
Level 1

I have a callmgr 5.1 with Unity 5.0. Incoming service is via a T-1 CAS, e&m-wink start ckt.

Incoming call hits unity auto attendant and transfers to user. IP phone rings an ddisplay shows "unknown number".

Should display show caller id assuming carrier is sending it? If so, is there any config needed to enable it? How can I verify carrier is sending it?

gateway is mgcp-2821.

thanks

Rob

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Hi,

usually T1 CAS in itself doesn't support caller-id, and then MGCP again doen't as well.

As you telco for PRI on the circuit, reconfigure router and CCM, and you will have caller-id.

Hope this helps, please rate post if it does!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: