cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
260
Views
0
Helpful
1
Replies

Viewing config on standby sup720

richard.murphy
Level 1
Level 1

Hi,

I have a 6500 with two sup720's installed they are in an active and standby state.

They are both running in a hybrid mode using CatOS cat6000-sup720k8.8-3-6.bin & c6msfc3-psv-mz.122-17d.SXB9.bin on the MSFC3

My question is, is there anyway to view the CatOS config on the standby card ?

We have recently swapped the standby card out for a replacement and I would now like to view the config on it to see if the active card has synced the config over correctly ?

Thanks in advance.

Rich

1 Reply 1

owillins
Level 6
Level 6

Use show tech commands. You will get the info.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco