Solved: Cisco 2600 Configuration Problem

jcavazos71 · ‎01-14-2008

This is my first router configuration. I am having problems with 192.168.50.0/24 network getting to other networks (192.168.51.0/24)

mounir.mohamed · ‎01-14-2008

Welcome :)

Please mark the conversation as solved if the posts resolve your issue.

Best Regards,

Mounir Mohamed

View solution in original post

dabels · ‎01-14-2008

can I ask why you are nat'ing? also do you have a device on the two separate networks and do they have the correct subnet mask on them? if you do a traceroute from one device to the other what is the result?

mounir.mohamed · ‎01-14-2008

Hi,

This due to wrong Wildcard bits, use the below ACL format to allow directlly connected subnet to overloaded by F0/0 ip address, the ACL you used only allow any ip address ended by 0 which is not valid address in your case, so you can correct it by use this format:

access-list 7 permit 192.168.50.0 0.0.0.255

Pls rate helpful posts.

Best Regards,

Mounir Mohamed

jcavazos71 · ‎01-14-2008

Thanks, mounir.mohamed

That did the trick... it works now.

mounir.mohamed · ‎01-14-2008

Welcome :)

Please mark the conversation as solved if the posts resolve your issue.

Best Regards,

Mounir Mohamed