how to change configuration using SNMP

Answered Question
Jan 15th, 2008
User Badges:

i have 3560 device on remote site and due to some wrong configuration tacac communication is getting failed and switch is now directly asking for password however it gives authorization failed when i put in.

is there any way by which i can fetch the config via snmp and change configuration and reconfigure the switch.

i tried using cwconfig features but getting authentication failed error is popping up.


Correct Answer by David Stanford about 9 years 6 months ago

You can use any snmp utlity...you would just query / set the same snmp OID's

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
roger.malik Tue, 01/15/2008 - 07:25
User Badges:

Hi davistan,


this require hpopenview and solaris. i dont have any of them, is this still possible ?

Correct Answer
David Stanford Tue, 01/15/2008 - 07:38
User Badges:
  • Cisco Employee,

You can use any snmp utlity...you would just query / set the same snmp OID's

Actions

This Discussion