Creating a dot1q trunk on a 7200

Unanswered Question
Jan 16th, 2008
User Badges:

okay...I must be loosing my mind. I'm trying to configure a fastethernet interface on a 7200 to be a 802.1q trunk to a Cisco 4000 switch.

I created the subinterface:

fastethernet 0/0.1

but in the subinterface config there's no encapsulation command.


What am I missing here?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Wed, 01/16/2008 - 09:52
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi Frank


The 7200 does support 802.1q so it is probably the feature set that you are missing. You need a minimum of IP Plus to support 802.1q encapsulation.


HTH


Jon

ankbhasi Wed, 01/16/2008 - 09:52
User Badges:
  • Cisco Employee,

Hi Frank,


I hope you are not running IP BASE feature set image. You need minimum IP PLUS to support encapsulation command.


HTH


Ankur

ajagadee Wed, 01/16/2008 - 09:54
User Badges:
  • Cisco Employee,

This could be an issue with the code that you are running on the 7200. If I remember correctly, you need a minimum of IP Plus feature set to do 802.1q encapsulation.



Regards,

Arul

Actions

This Discussion