01-16-2008 09:48 AM - edited 03-05-2019 08:30 PM
okay...I must be loosing my mind. I'm trying to configure a fastethernet interface on a 7200 to be a 802.1q trunk to a Cisco 4000 switch.
I created the subinterface:
fastethernet 0/0.1
but in the subinterface config there's no encapsulation command.
What am I missing here?
01-16-2008 09:52 AM
Hi Frank
The 7200 does support 802.1q so it is probably the feature set that you are missing. You need a minimum of IP Plus to support 802.1q encapsulation.
HTH
Jon
01-16-2008 09:52 AM
Hi Frank,
I hope you are not running IP BASE feature set image. You need minimum IP PLUS to support encapsulation command.
HTH
Ankur
01-16-2008 09:54 AM
This could be an issue with the code that you are running on the 7200. If I remember correctly, you need a minimum of IP Plus feature set to do 802.1q encapsulation.
Regards,
Arul
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: