No NHRP support?

Unanswered Question


I am in the process of building a template for DMVPN Spokes on the Cisco 828. During the initial phase, I noticed that 12.4(5c) in the k9osy6-mz suite lack support for NHRP.

After a few searches I came up with "", which doesn't specifically speak about this, but mentions the use of NHRP on this platform, and some issues with NHRP covered in "CSCin95836".

Was NHRP support removed in 12.4, or am I missing something? The router will not accept any "ip nhrp" command.

I've tried this on 12.3(9) and 12.4(5c).

Router(config)#int tunnel0

Router(config-if)#ip nhrp ?

% Unrecognized command

Any input is apreciated!

Best regards,

Tord Forland - Norway

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion