Rob Huffman Fri, 01/18/2008 - 05:51
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Nicola,


No, you should be fine here. This is the only restriction that I have seen for this;


User cannot be Authenticated / Unable to Connect to the LDAP Server


After the installation of the Active Directory plug-in for Cisco CallManager in a Multi Level Administration (MLA) environment, access to the administration pages fails with the You can not be authenticated successfully. Unable to connect to the LDAP server error message.


In a Cisco CallManager environment where MLA is enabled, if the Active Directory plug-in is installed, access to the administration pages is lost. You can observe this problem if MLA is installed before the Active Directory plug-in is installed. Install the Active Directory plug-in before the MLA installation.


Complete these steps in order to address this issue:


Uninstall MLA.


Refer to the Uninstalling Cisco CallManager Multilevel Administration Access section of the Cisco CallManager Multilevel Administration Access Guide.


Re-install the Active Directory plug-in.


Refer to Active Directory 2000 Plug-in Installation for Cisco CallManager.


Re-install MLA.


Refer to the Installing Cisco CallManager Multilevel Administration Access section of the Cisco CallManager Multilevel Administration Access Guide.


From this good doc;


Active Directory and Cisco CallManager Integration Troubleshooting Guide


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00801d3c48.shtml#ldapsvr



This doc also has some good info;


http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_1_3/ccmcfg/b07mla.html#wp1022546


Hope this helps!

Rob

Actions

This Discussion