How do I reset the values displayed by the SHOW BOOT command

Answered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (3 ratings)
Loading.
Danilo Dy Fri, 01/18/2008 - 06:31

Hi,

Is this a router or a switch and what model?

Regards,

Dandy

Dear Dandy,

This is a switch model Catalyst 3500 series XL model WS-C3534-XL-EN.

I have now resolved one issue setting "Config file:" to "flash:config.text" by entering "configure terminal" mode followed by the "BOOT config-file flash:config.text" command.

I still wish to set the “BOOT path-list:” to a null value.

In addition I wish to set the “Enable Break:” from a value of “1” to a value of “no”.

Danilo Dy Fri, 01/18/2008 - 07:45

Hi,

To set enable break from 1 (or yes) to 0 or (no);

switch# config t

switch(config-t)#no boot enable-break

To set boot path-list to null

switch# config t

switch(config-t)#no boot system

Regards,

Dandy

Correct Answer
Danilo Dy Fri, 01/18/2008 - 08:08

Hi,

Did you use "no boot system"? I edit the early post from "no boot boothlpr" to "no boot system"

Regards,

Dandy

Actions

This Discussion