01-18-2008 06:29 AM - edited 03-05-2019 08:33 PM
After the SHOW BOOT command how do I set the "BOOT path-list:" to a null value and how do I set the "Config file:" to a value of "flash:config.text"?
Solved! Go to Solution.
01-18-2008 08:08 AM
Hi,
Did you use "no boot system"? I edit the early post from "no boot boothlpr" to "no boot system"
Regards,
Dandy
01-18-2008 06:31 AM
Hi,
Is this a router or a switch and what model?
Regards,
Dandy
01-18-2008 07:34 AM
Dear Dandy,
This is a switch model Catalyst 3500 series XL model WS-C3534-XL-EN.
I have now resolved one issue setting "Config file:" to "flash:config.text" by entering "configure terminal" mode followed by the "BOOT config-file flash:config.text" command.
I still wish to set the âBOOT path-list:â to a null value.
In addition I wish to set the âEnable Break:â from a value of â1â to a value of ânoâ.
01-18-2008 07:45 AM
Hi,
To set enable break from 1 (or yes) to 0 or (no);
switch# config t
switch(config-t)#no boot enable-break
To set boot path-list to null
switch# config t
switch(config-t)#no boot system
Regards,
Dandy
01-18-2008 08:04 AM
Dear Dandy,
The set enable break from 1 (or yes) to 0 or (no);
switch# config t
switch(config-t)#no boot enable-break
has worked OK.
However the "BOOT path-list: flash:c3500XL-c3H2s-mz.120-5.WC3b.bin" still remains!
01-18-2008 08:08 AM
Hi,
Did you use "no boot system"? I edit the early post from "no boot boothlpr" to "no boot system"
Regards,
Dandy
01-18-2008 08:32 AM
Dear Dandy,
The "no boot system" seems to have done the trick.
I will rate the call on my return from vacation.
Best Regards, Steve
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: