01-18-2008 10:58 AM - edited 03-05-2019 08:34 PM
01-18-2008 11:44 AM
Are you saying your router goes back to defaults after losing power. If so, are you writing the configuration to memory after making changes? After making config changes, issue the "wr mem" command.
Hope this helps.
Brandon
01-18-2008 11:46 AM
How would I do this in SDM express?
Thanks Tom
01-18-2008 11:54 AM
Tom,
Looks like from the following link, there should be an Apply Changes button.
Brandon
01-18-2008 12:27 PM
Still does not work....
01-18-2008 12:31 PM
Can you telnet or console to the router and issue the "wr mem" command after making a config change and see if that helps?
Brandon
01-18-2008 01:28 PM
Could it be bad flash
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide