JORGE RODRIGUEZ Fri, 01/18/2008 - 14:47

Sunil, I have 5 snmp server hosts without any issues.. I am at code 8.x, do you get save error from asdm or cli, what is the exact error you are getting ?


this is my config from show run


snmp-server host inside 10.168.100.38 community public

snmp-server host inside 10.2.2.244 community public

snmp-server host inside 10.3.2.244 community public

snmp-server host inside 10.6.7.24 community public

snmp-server host inside 192.168.14.44 community public



srego4 Fri, 01/18/2008 - 19:47


My version is 7.2(2)


the ios is asa722-k8.bin


Looks like I need to upgrade.... I get the error from the cli... the gui (asdm) does not give any error.. I dont believe the ADSm is as reliable as yet (good for normal config ...but not all)


This is the error I get if I add a fifth snmp server using cli and try to save

%Error reading system:/running-config (Configuration line too long)

Error executing command

[FAILED]




JORGE RODRIGUEZ Fri, 01/18/2008 - 21:03

bug.. ID# CSCsg87808


http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsg87808&from=summary



'wr mem' fails due to snmp config; Error: (Configuration line too long)

Symptom:

If snmp-server commands are configured, in a rare corner case

the configuration might fail to save to flash and give the error like below:


pix# wr mem

Cryptochecksum: ee8f5816 e1ce1ad7 83151424 f1a3b6fc %Error

reading system:/running-config (Configuration line too long)

Error executing command [FAILED]


Conditions:

The firewall must have snmp-server commands configured and running

version 7.2(1)25 or greater (includes 7.2(2)).


Workaround:

Remove the snmp-server commands from the configuration

-or-

downgrade to a version of code previous to 7.2(1)25




Rgds

Jorge

srego4 Sun, 01/20/2008 - 07:39

Thanks Jorge for teh bug id.


But rather than downgrade as Cisco suggests I will try the version you are using (8) as you seem to have it working.


Thanks again.

JORGE RODRIGUEZ Sun, 01/20/2008 - 10:52

The upgrade to 8.0 is fairly straight forward, I was running 7.2 and went straight to latest code 8.03 without issues.


Don't forget to upgrade the ASDM as well, bellow is the information.


http://www.cisco.com/cgi-bin/tablebuild.pl/asa


ASA Code : asa803-k8.bin

ASDM : asdm-603.bin



If you want to read a bit on 8.0(3) code updates etc.. here is a link.


http://www.cisco.com/en/US/docs/security/asa/asa80/release/notes/arn803n.html#wp23144



Rgds

Jorge



Actions

This Discussion