I have 2 new T1 circiuts installed for a point to point connection between two offices. I have not worked with a cisco router in quite some time.
The topology I have now:
Office 1 network = 192.168.100.0
Office 2 network = 192.168.200.0
2*T1 = 3.0Mbps Point to Point
Here is my current configuration that I have setup so far:
Fast Ethernet0/0 IP = 192.168.100.250
IP default-network 192.168.100.0
Fast Ethernet0/0 IP = 192.168.200.250
IP default-network 192.168.200.0
I added this routing:
Ip Route 192.168.200.0 255.255.255.0 192.168.200.250
IP Route 0.0.0.0 0.0.0.0 192.168.200.250
If I run command 'show ip route' I get this: "Gateway of last resort is not set"
What are the steps I should take to get this point to point operational ultilizing the 3.0Mbps for it.