dial-peer load balancing

Unanswered Question
Jan 20th, 2008

hi.

I do below configuration in a (C) router.

A Router and B router was connected

the same PBX(number 5555).

A(1.1.1.1) ----------|

|-(C)

B(2.2.2.2) ----------|

(C) router configuration.

dial-p 1 v voip

destination-p 5555

sesion target ipv4:1.1.1.1

dial-p 2 v voip

destination-p 5555

session target ipv4:2.2.2.2

1.1.1.1(A) and 2.2.2.2(B) is not same router.

when i configure other dial-peer for same number(5555),

I checked call session was balanced to the two router.

for the example,

first call go to the A router.

second call go to the B router.

is this normal symptom?

like acl rule

i want to know dial-peer match rule.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Sun, 01/20/2008 - 10:28

Yes, without a configured preference, calls will go round-robin. You can change that wiht "dial-peer hunt " - type ? to see the possible choices.

Hope this helps, please rate post if it does!

Actions

This Discussion