health Check Using Network Assistant

majdalani · ‎01-20-2008

hi,

I usually use Cisco Network Assistant to check and perfom configuration for my 2950 / 2970 switches.

I Need to check my switches healthes, so i went to the monitoring options and i see bandwidth graph, CPU, Memory, Utilization.

Is there any average % for any of these.

For example if the Utilization is shown in the graph to be 35 % is this good or bad ?

Thanks in advance.

jsivulka · ‎01-25-2008

There is no any average % for bandwidth graph, CPU, Memory, Utilization. It will differ by using traffic as well as network utilization.

majdalani · ‎01-25-2008

Hi,

Thanks for your reply.

But once i click on the above link, i recieve file forbidden page !