Catalyst 6509 FlexWAN problem & redundant SupEng different bootvar problem

Unanswered Question
Jan 21st, 2008


1. I have a Catalyst 6509 with FlexWAN & ATM OC3 module. Last week this switch reloaded. All configuration back exceptd ATM module configuration. The ATM module configuration was exist at "show start", but not exist at "show runn". I copy ATM module configuration from startup-config to running-config, It work again. Can you please help to identify the problem?

2. Another strange sympton is when execute "show bootvar", the two supervisor engine have different parameter. Even I change "boot system" & "config-register" again, the boot parameter between two supervisor engine still different. Please also gove me some help to solve this problem.

Best Regards,

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion