6500 Gigabit Cards - Deafult input hold-queue

Unanswered Question
Jan 21st, 2008

Guys,


I have a 6500 running with WS-6724-SFP fibre gigabit cards


Now, some interfaces show the input queue (when the port is disabled) as 2000 and when enable at 75 as below


GigabitEthernet1/19 is administratively down, line protocol is down (disabled)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet1/20 is administratively down, line protocol is down (disabled)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet1/21 is administratively down, line protocol is down (disabled)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet1/22 is up, line protocol is up (connected)

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet1/23 is up, line protocol is up (connected)

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet1/24 is up, line protocol is up (connected)

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet2/1 is up, line protocol is up (connected)

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet2/2 is administratively down, line protocol is down (disabled)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet2/3 is administratively down, line protocol is down (disabled)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet2/4 is administratively down, line protocol is down (disabled)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet2/5 is administratively down, line protocol is down (disabled)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

GigabitEthernet2/6 is administratively down, line protocol is down (disabled)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0



but, on another card where a port-channel is configured, the port channel shows an input-queue of 2000 and the phy interface inherits that input queue???


Port-channel68 is up, line protocol is up (connected)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0

Port-channel69 is up, line protocol is up (connected)

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0




I have not configured any hold-queue commands on my switches? How can this happen?


Many thx, and kind regards,

Ken

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion