Guys,
I have a 6500 running with WS-6724-SFP fibre gigabit cards
Now, some interfaces show the input queue (when the port is disabled) as 2000 and when enable at 75 as below
GigabitEthernet1/19 is administratively down, line protocol is down (disabled)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet1/20 is administratively down, line protocol is down (disabled)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet1/21 is administratively down, line protocol is down (disabled)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet1/22 is up, line protocol is up (connected)
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet1/23 is up, line protocol is up (connected)
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet1/24 is up, line protocol is up (connected)
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet2/1 is up, line protocol is up (connected)
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet2/2 is administratively down, line protocol is down (disabled)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet2/3 is administratively down, line protocol is down (disabled)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet2/4 is administratively down, line protocol is down (disabled)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet2/5 is administratively down, line protocol is down (disabled)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
GigabitEthernet2/6 is administratively down, line protocol is down (disabled)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
but, on another card where a port-channel is configured, the port channel shows an input-queue of 2000 and the phy interface inherits that input queue???
Port-channel68 is up, line protocol is up (connected)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Port-channel69 is up, line protocol is up (connected)
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
I have not configured any hold-queue commands on my switches? How can this happen?
Many thx, and kind regards,
Ken
