Configuring Transcoding and Conferencing

Unanswered Question

I'm attempting to configure transcoding and conferencing on my Cisco 2811. We're running CME and CUE. I did not setup this router initially, so there are gaps of knowledge about my own config. I know that we have conferencing setup, but I cannot figure out how to run transcoding along side of it. Here are the lines from my config that I believe are pertinent.

!

voice-card 0

dspfarm

dsp services dspfarm

!

sccp local FastEthernet0/0

sccp ccm 192.168.100.253 identifier 1

sccp

!

sccp ccm group 1

associate ccm 1 priority 1

associate profile 1 register mtp001cf6806720

keepalive retries 5

switchover method immediate

switchback method immediate

switchback interval 5

!

dspfarm profile 2 transcode

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

maximum sessions 8

associate application SCCP

!

dspfarm profile 1 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

maximum sessions 4

associate application SCCP

some results from a 'show diag' are below:

Slot 0:

C2811 Motherboard with 2FE and integrated VPN Port adapter, 2 ports

PVDM Slot 0:

16-channel (G.711) Voice/Fax PVDMII DSP SIMM PVDM daughter card

PVDM Slot 1:

48-channel (G.711) Voice/Fax PVDMII DSP SIMM PVDM daughter card

WIC Slot 2:

2nd generation - FXO Voice daughter card (4 port)

WIC Slot 2:

2nd generation - FXO Voice daughter card (4 port)

WIC Slot 3:

FXS Voice daughter card (4 port)

I've looked at all of the documentation for this subject, and I'm not sure I've found the case that applies to my hardware setup.

Thanks for the assistance.

pk

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion