I'm attempting to configure transcoding and conferencing on my Cisco 2811. We're running CME and CUE. I did not setup this router initially, so there are gaps of knowledge about my own config. I know that we have conferencing setup, but I cannot figure out how to run transcoding along side of it. Here are the lines from my config that I believe are pertinent.
!
voice-card 0
dspfarm
dsp services dspfarm
!
sccp local FastEthernet0/0
sccp ccm 192.168.100.253 identifier 1
sccp
!
sccp ccm group 1
associate ccm 1 priority 1
associate profile 1 register mtp001cf6806720
keepalive retries 5
switchover method immediate
switchback method immediate
switchback interval 5
!
dspfarm profile 2 transcode
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729r8
codec g729br8
maximum sessions 8
associate application SCCP
!
dspfarm profile 1 conference
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729r8
codec g729br8
maximum sessions 4
associate application SCCP
some results from a 'show diag' are below:
Slot 0:
C2811 Motherboard with 2FE and integrated VPN Port adapter, 2 ports
PVDM Slot 0:
16-channel (G.711) Voice/Fax PVDMII DSP SIMM PVDM daughter card
PVDM Slot 1:
48-channel (G.711) Voice/Fax PVDMII DSP SIMM PVDM daughter card
WIC Slot 2:
2nd generation - FXO Voice daughter card (4 port)
WIC Slot 2:
2nd generation - FXO Voice daughter card (4 port)
WIC Slot 3:
FXS Voice daughter card (4 port)
I've looked at all of the documentation for this subject, and I'm not sure I've found the case that applies to my hardware setup.
Thanks for the assistance.
pk