PagP Priority

Unanswered Question
Jan 21st, 2008
User Badges:

Hi!


I want to create an Etherchannel with two ports, but I would like than one port carry more traffic than the other. Is this possible? I've seen there is a "priority" command in the pagp configuration to assign port priority, but I am not sure if this works like I would like to...


Thanks in advance!


Best regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
Jon Marshall Mon, 01/21/2008 - 11:07
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


You can't really control the load-balancing as such. You can configure which type of load balancing it will do ie. src/dst mac address, source/dst IP address, port numbers but not all switches support all types.


The Pagp priority command does not affect which link is used for load-balancing.


http://www.cisco.com/en/US/tech/tk389/tk213/technologies_tech_note09186a0080094714.shtml


Jon

juan-castillo Mon, 01/21/2008 - 11:17
User Badges:

OK! Thank you very much. I supouse I need to use a router to control the load.


Best regards!

Actions

This Discussion