01-22-2008 05:18 AM - edited 03-03-2019 08:21 PM
hi,
i have Cisco 7206VXR (NPE-G2). I want to terminate E1 module on that router.
Can anyone tell me which E1 moudle is supported on this plateform. I am searching the E1 module on cisco website but not getting the right one.
Please guide me.
One E1 moudle is installed on my 3825
VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1
will that moudule support in 7206.
I am waiting for reply
01-22-2008 08:59 AM
7200 and 2800/3800 do not share any common hardware. How many E1 ports do you need? The smaller module (port adapter) for the 7200 is PA-MC-2E1. Then there are 8 ports modules.
Hope this helps, please rate post if it does!
01-22-2008 12:23 PM
Thanks for the reply,
Can u please tell me is there any module that provide me Rj48 interface for E1. Because i am using 3825 with
VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1
that provide me RJ48. I wana have the same sort of module that provide 7206 with RJ48.
I am looking at cisco site but still not able to get it.
01-22-2008 01:45 PM
Yes, all are RJ48 interfaces. If you browse in the technical information for "port adapters" you will see them.
Thanks for the rating and good luck!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide