Solved: DFM 3.0.2 - Devices stuck in learning state - Cisco Community

719

Views

0

Helpful

3

Replies

Hi there again,

Started off on a fresh install of LMS 3.0.1 on Windows 2003 Enterprise box. I'm running into an issue where devices within DFM 3.0.2 are not getting past the learning state (stuck at 10%). Also, if I try to delete the devices, then they stay in the pending state unless I try rediscovering them.

Anyone else has experienced this type of issue?

1 Accepted Solution

Accepted Solutions

look at the following thread how to trobleshoot this issue:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddead5c

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddd1ffc

View solution in original post

3 Replies 3

look at the following thread how to trobleshoot this issue:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddead5c

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddd1ffc

Thanks for the threads. Based on them, I believe I have resolved the problem. Specifically I needed to append the DNS suffix to the hostname under:

My Computer > Properties > Computer Name > Change > More

Does same in Solaris 3.1.

Learn, share, save

Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.

New here? Get started with these tips. How to use Community New member guide

Log in to Community