Architecture issue with 2106 controller

Unanswered Question
Jan 22nd, 2008
User Badges:

I have a 2106 controller. I want to connect two LWAPP 1131 directly on the two POE ports. I also want to connect a port on a Firewall in order to administrate the controller through the firewall.


The issue is that the management interface must be accessible for the AP and for a PC through the firewall. But the management interface can be assign to only one port.


Any idee?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ankbhasi Tue, 01/22/2008 - 09:59
User Badges:
  • Cisco Employee,

Hi Friend,


Management ip address should be reachable by APs and not interface. So you can map your management interface to port 1 and connect you APs to port 7 & 8 and they will join your controller.


If I am not able to understand your doubt please come back again with the same.


HTH


Ankur


*Pls rate all helpfull post

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode