bonding two T1a-Frame Relay point-point

Unanswered Question
Jan 22nd, 2008
User Badges:


A new production router/perimeter router will have a 3M Internet link by bonding two T1 lines. How does a Multilink Frame Relay point-to-point configured? In the following attachment, int. Multilink 1 will not accept configuration for frame relay point-to-point. Much appreciate assistance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Tue, 01/22/2008 - 14:52
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Before getting into the details of the features, is the router on the other side also configured for either MLPPP or ML-FR ?

saidfrh Tue, 01/22/2008 - 15:05
User Badges:

The data sheet from the ISP states, "Service Type: Multilink Frame Relay, with a dlci: (number)

On a separate sample sheet provided by the ISP:

"interface MFR0

no ip address

frame-relay lmi-type ansi

interface MFRO.# point-to-point (dlci#)

ip address x.x.x.x (customer WAN Ip address)

frame-relay interface-dlci # IETF (dlci#)"


This Discussion