01-22-2008 01:58 PM - edited 03-03-2019 08:22 PM
I have 3 sites. one is HQ and the other two are branches. The branches connect to HW via serial lines and the Branches connect to each other via Fast Ethernet lines. I would like to give the sites a default route via eigrp ip summary commands and have fail over. I have pushed the default route from HQ, but fast ethernet side shows as path for all other networks. How can I make the Fast ethernet side a backup default route with no route advertisements?
01-22-2008 02:07 PM
Hi
The problem is that fastethernet link is preferred over serial because of bandwidth and delay.
You can
1) Modify the delay so that the serial link is preferred in each of your remote sites
2) Make the fast ethernet interfaces under EIGRP passive interfaces on your remote routers and then use a floating static route which will only be used if the default-route from HQ disappears.
HTH
Jon
01-23-2008 04:03 PM
I set the bandwidth and delay on the fast ethernet interfaces, set the passive interface on both remote routers and implemented a floating static route with a AD of 91.
thanks for your help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide