Is there a way to unify multiple Voice ISDN-BRI to single group?

Unanswered Question
Jan 23rd, 2008

I'm just wondering is there a way to unify multiple BRI interfaces in signle than to include it in the dial-peer for easier call routing.

Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Paolo Bevilacqua Wed, 01/23/2008 - 02:03

Absolutely, trunk-groups:

int bri x/y

trunk-group telco

dial-peer voice 100 pots

destination-pattern ...

trunkgroup telco

Then, under "trunk group telco" you can optionally configure translation-profiles, hunt schemes and other things. "show trunk group" will give you the status of all the circuits in there.

Hope this helps, please rate post if it does!

z.zdravkov Wed, 01/23/2008 - 04:03

Thank you very much. It is very helpful. I just found this commands but wasn't sure are they working.

Now I'm goint to try them.

Thank you.


This Discussion