01-23-2008 04:12 AM - edited 03-05-2019 08:39 PM
Hi,
I am getting following error when I boot 7206VXR router with NPE-300 from rommon
*** Bus Error (Load) Exception ***
Access address = 0x826e5bc1
PC = 0x8000af3c, Cause Reg = 0x1c, Status Reg = 0x3040d003
monitor: command "boot" aborted due to exception
Please advice.
Thank you,
Tresa
01-23-2008 09:24 AM
Try a different IOS image to start with, see if you can get anywhere with that. Might also be an issue with the boot media.
01-23-2008 09:30 AM
Hi,
You mean issue with flash ?
Could it be a problem with I/O controller ?
or could it be a problem with boot loader image. Only somtimes this error is dispalyed when booting from rommon. The booting is not booting with IOS image . No error message I am getting at that time. The booting stops and by break sequence I can enter rommon and boot with same IOS I have given in boot system command.
Thanks,
Tresa
01-23-2008 10:35 PM
I've seen a problem very similar to that before and I think it's related to the flash disk, but I'm not 100% sure. If you have the time/ability I'd try either formatting and reloading the IOS onto the flash or trying a new disk just for testing.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: