We have a setup of two AP (1242AG), one using IOS 12.3(8) and the other with IOS 12.4(3g). The idea is to configure the 5GHz radio such, that it only uses the band 1. The configuration does only allow to use dfs in this band. When the two AP have been started, both selected the same channel.
The configuration says that the channel of radio 1 is set to use dfs. Using âshow controllers dot11Radio 1â shows that channel 40 is selected but DFS is not enabled. Using âdebug dot11 dot11Radio 1 dfs simulateâ also indicates that DFS is not enabled, even if the channel has been set to use dfs.
- Is there a possibility to enable dfs in the band 1?
- How can the two AP be configured, that they do not transmit on the same frequency?