QoS priority queueing on Cat 6500

Unanswered Question
Jan 23rd, 2008
User Badges:

Just a quick configuration question!! Why does the config line for priority queueing does not appear in running config. How to verify that it is setup properly?


For example "priority-queue cos-map 1 5"

will not appear in the running config.


Any thoughts!!!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jon Marshall Wed, 01/23/2008 - 15:02
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


Because this is the default ie. COS value 5 is mapped to the priority queue (assuming the module has one).


If you went onto an interface and did


int gi8/1

priority-queue cos-map 1 3


then it would then show in the running config as


int gi8/1

priority-queue cos-map 1 3 5


because you have changed from the default.


To verify see this example from one of our 6500 switches


SZ-JFH-F00-DTE1#sh queueing int gi8/1

Interface GigabitEthernet8/1 queueing strategy: Weighted Round-Robin

Port QoS is enabled

Trust state: trust DSCP

Extend trust state: not trusted [COS = 0]

Default COS is 0

Queueing Mode In Tx direction: mode-cos

Transmit queues [type = 1p2q2t]:

Queue Id Scheduling Num of thresholds

-----------------------------------------

1 WRR low 2

2 WRR high 2

3 Priority 1 ***** priority queue is mapped to queue 3 *****


WRR bandwidth ratios: 100[queue 1] 255[queue 2]

queue-limit ratios: 70[queue 1] 15[queue 2] 15[Pri Queue]*same as Q2


queue random-detect-min-thresholds

----------------------------------

1 40[1] 70[2]

2 40[1] 70[2]


queue random-detect-max-thresholds

----------------------------------

1 70[1] 100[2]

2 70[1] 100[2]


queue thresh cos-map

---------------------------------------

1 1 0 1

1 2 2 3

2 1 4 6

2 2 7

3 1 5 ***** and here is cos value 5 mapped to queue 3 by default *****


Queueing Mode In Rx direction: mode-cos

Receive queues [type = 1q2t]:

Queue Id Scheduling Num of thresholds

-----------------------------------------

1 Standard 2



queue tail-drop-thresholds

--------------------------

1 100[1] 100[2]


queue thresh cos-map

---------------------------------------

1 1 0 1 2 3 4 5 6 7


SZ-JFH-F00-DTE1#


HTH


Jon

Actions

This Discussion