Gilles Dufour Wed, 01/23/2008 - 23:10
User Badges:
  • Cisco Employee,

you have both 7000 frontend and backend.


service web-7000

ip address x.x.x.x

port 7000

active


owner MyCompany

content https-7000

vip address x.x.x.x

port 7000

add service web-7000

active


Use the 'port' command to select the frontend and backend port.

You can change it to whatever you want and it does not need to match.


Gilles.

naive.naive Wed, 01/23/2008 - 23:15
User Badges:

thanks for the prompt response..


but do i have to configure anything for it to run https on the front end?

Gilles Dufour Thu, 01/24/2008 - 04:41
User Badges:
  • Cisco Employee,

the CSS does not do HTTPS.

So, you can send HTTPS traffic, and the CSS will loadbalance it to the servers that will terminate the SSL connection.


If you want to use SSL on the frontend and HTTP on the backend, you need an SSL module.

Without the SSL module, this is not possible.


Gilles.

naive.naive Sun, 01/27/2008 - 08:26
User Badges:

gilles,


but im not terminating the https on the CSS, for eg, i want the CSS to load balance https://1.1.1.1:7002, backend also on port 7002 (https) , rather than the usual port no 443


can you post sample of the config?


sorry for troubling u..


thanks..

Actions

This Discussion