Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
346
Views
0
Helpful
1
Replies

Help - Configure AP 1242AG

sam-lee
Level 1
Level 1

‎01-24-2008 12:13 AM - edited ‎07-03-2021 03:15 PM

Hi,

Does anyone know how to configure the AP, so that the AP ip address and wireless user ip address in different subnet?

Labels:
0 Helpful
1 Reply 1

bcolvin
Level 3
Level 3

‎01-25-2008 02:20 PM

Sam

you need to configure a VLAN for the AP (Native) and another VLAN for the SSID used by the client you also need to cofigure the switch port for dot1q trunking. it is reccomended you use the GUI/Web browser interface to do this as ther are many interrelated settings and the usint the Web interface takes care of them.

Good Luck

Bill

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card