config 16 T1

Unanswered Question
Jan 24th, 2008


I config the AS54 with 16 T1. it will receive "886" and "65" prefix.

do I need to config 16 dialpeer for 886 and config 16 dialpeer for 65? (total 32 dial peer). any work around to reduce the dial peer?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Paolo Bevilacqua Thu, 01/24/2008 - 09:37

No, you use trunkgroups:

int serial x/y:23

trunk-group my-tg

dial-peer voice 866 pots

destination-pattern 866

trunkgroup my-tg

Then under "trunk group my-tg" you can optionally configure things like translation-rules, hunt scheme and more. Do "show trunk group" and you will see all what the lines are doing.

There is also a configuration for DP using alternate match patterns what would allow grouping 886 and 65 in a single destination-pattern, but probably is just confusing and not necessary.

Hope this helps, please rate post if it does!


This Discussion