1310 wireless bridges - gui shows no config, but seen in CLI after update

Unanswered Question
Jan 24th, 2008

We have a pair of 'legacy' 1310 bridges that serve as a backup radio link to our primary 1400 bridges. I updated the IOS on both root and remote bridges to 12.3(2)JA4. Subsequently, I see that the G radio interfaces of both bridges are down. Through the GUI I see the log states "No SSID with VLAN configured. Dot11Radio0 not started." Upon further investigation I find that through the GUI none of the running/startup configuration is in place - No VLANs defined, No SSID, etc. However, through the CLI the configuration is all in tact. Anyone see this before?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion



Trending Topics - Security & Network