01-25-2008 12:03 AM - edited 03-11-2019 04:53 AM
Hi!
Are there anybody here tried to setup A/A failover or A/S Failover with DMZ support?
I read the docu found here
http://cco.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/config/failover.htm#40447
and it seems DMZ support is not supported. correct me if im wrong. I attached the network topology.
Need your comments. Thank you!
01-29-2008 02:25 PM
I can't figure out if I have to dedicate an interface on the ASA JUST for failover/stateful traffic.
01-29-2008 04:44 PM
In order to implement failover either A/A or A/S you must dedicate 1 port for failover.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide