change audit report issue and config archive

Unanswered Question
Jan 25th, 2008
User Badges:

I run a 24 hour change audit report and I see that every device gets updated everyday due to ntp-clock-period change, for instance I see two entries when I compare the configuration.

version 1--ntp clock-period 36029426

version 2--ntp clock-period 36029429

Anyone seen this? I'm running rme 4.0.5 on Solaris 9.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
David Stanford Fri, 01/25/2008 - 07:38
User Badges:
  • Cisco Employee,

You'll need to exclude the commands:

Log in to LMS:

Go to RME -> Admin -> Config Management -> Archive Management -> Exclude Commands

Select the device type in the list on the left then in the right pane called

Exclude commands, write ntp clock-period, if there are multiple commands

you'll notice they are comma separated so just add this to the end of the

list ,ntp clock-period after this you'll stop the ntp changes from

triggering the config fetches,


This Discussion