01-26-2008 02:26 PM - edited 03-03-2019 08:26 PM
I blew away the factory config that came with my 871w router. now i can not use my sdm disk because it is looking for the 10.10.10.1 ip scheme. can anyone please provide this config so i can start using my router?
01-31-2008 12:23 PM
For the fresh configuration of the router follow the below steps:
Sample procedure is as follows:
Router#config t
Router(config)#config-reg 0x2142
Router(config)#end
Router#show version (check the last line of the output)
Router#reload
When the router reloads, please type this command:
Router#write memory
Router#config t
Router(config)#config-reg 0x2102
Router(config)#end
Router#reload
At this moment, your router is at Factory default and ready to set any configuration.
Or another way is:
Router#write erase
or
Router#erase nvram:
01-31-2008 03:13 PM
On the 8xx, two more ways:
copy flash:c871-default-sdm.cfg startup-config
reload
(I made up the exact flash filename, do dir and you will see it)
or press the reset button just after turning on.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: