Bundeling of wireless bridges.

Unanswered Question
Jan 27th, 2008


I need best practice advice on the folowing :

2 buildings are connected trough a wireless brigde link. Both are 1300 bridges.

Building A has an 2950

Building B has an 3750

I want to add another bridge to up my bandwidth. From reading on this site, etherchannel is not an supported practice, i cannot load balance on l3 since i do not have routers on both sides.

I was thinking of creating dual trunks and dividing the vlans on the bridges and use pvst.

Any advice ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode