01-28-2008 12:54 AM - edited 03-03-2019 08:27 PM
Hi,
I have an 1812 cisco router, and I have been trying to set this thing up for about a month now.
I am using SDM to setup the router but I am unable to set it up successfully.
My enviornment:
-I have a SBC DSL Connection
-Cisco 1812 router
So far via SDM, I have configured my VLan1 to the IP 192.168.1.1 255.255.255.0. My Fast Ethernet 0 or 1 is not setup yet.
Can someone help me setup my FE0 so that I may access the internet. Remember I connect to the internet using SBC DSL.
Please help
01-28-2008 01:44 AM
Can you please clarify what exactly u want to do?
you want to route data from your router to the SBC DSL Connection Modem or what?
02-06-2008 04:36 AM
Correct,
I want my cisco router 1812 to act as the main router for my DSL connection.
Right now I have the SBC DSL modem connected to the FE0 port via Cat 5. My computer is connected to port 2 via cat 5.
Please help!!!!
02-06-2008 05:46 AM
scenario is still not explained. do you have single computer or you want internet on multiple computers.
02-06-2008 10:15 PM
I want the internet on multiple computers, I will connect all of my computers via the 1812. Please let me know if you need more information and thanks for the help thus far
02-07-2008 04:04 AM
hi
you need to use NAT on the router. use following commands
int fa0 ( interface connected to internet)
ip nat outside
int fa1
ip nat inside
ip access-group 150 in
ip nat inside source list 150 interface fa0 overload
access-list 150 permit ip any any
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide