IPSec VPN using loopback addresses

Unanswered Question
Jan 28th, 2008
User Badges:

Hi all,


I'm trying to set up (what I thought to be) a simple IPSec VPN connection between two routers using the loopback addresses as endpoints but I am having big problems implementing it. The tunnel goes from R1 to R3 through R2 and the IGP used is EIGRP. I've attached the configuration files for both routers.


When I try to do an extended ping from F0/0 on R1 to F0/0 on R3, it fails. With a "debug ip packets" on R3 I see that the source of the IP packets received is 100.1.1.1 (Se1/0 on R1).


What am I missing here to make all this work?


Thank you so much

Eduardo



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
eduardonpinto Mon, 01/28/2008 - 05:40
User Badges:

Case closed.


Right after I posted the question I found a mistake on the config:


"crypto map mymap local-address Loopback0"


should be


"crypto map myvpn local-address Loopback0"


Sorry for the bad post...

Actions

This Discussion