Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
309
Views
0
Helpful
3
Replies

CME dial peer

emmanuel.shoroma
Level 1
Level 1

‎01-28-2008 06:06 AM - edited ‎03-15-2019 08:27 AM

Hi, I am trying to configure a dial peer on CME but I am getting the following error.

I_to_I_Tech_CCME(config)#dial-peer voice 1 pots

ERROR: could not add peer

Please assist

Labels:
0 Helpful
3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

‎01-28-2008 06:12 AM

That is caused by a memory leak happening on both XJ and XW versions, I've experienced this also, but had not yet the strength to raise a case about.

Reload router and you will be able to configure the DP or ephone-dn.

Hope this helps, please rate post if it does!

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame
In response to paolo bevilacqua

‎01-30-2008 01:30 PM

Hi, watch out if you are experiencing this.

I suspect the meory leak is more serious than I tought, as apparently has caused total failure of ISDN with "cannot expand chunk" error messages. Reboot fixed it, but I'm downgrading IOS as a precaution.

0 Helpful

emmanuel.shoroma
Level 1
Level 1
In response to paolo bevilacqua

‎01-30-2008 09:54 PM

I rebooted the router as per your advice and it worked like magic. Thanks

0 Helpful
Customers Also Viewed These Support Documents