OSPF NBMA Config

Unanswered Question
Jan 28th, 2008
User Badges:

Hai,


i wud like to configure ospf in NMBA ...(Frame-Relay) ....My quiestion is Without a Frame-Relay switch is this possible ...is this possible by connecting router back to back ....how can i perform this ....


I want to perform the live cenario in LAB ...Pls help me


Kindly hlp me ...

Thanks in advance ...


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Hi There


How many routers do you have available to you.


You can make a Cisco router act as a Frame Switch. I use a 2520 with 4 serial ports as the Frame Switch in my home lab. I run a Frame Relay hub and spoke network with 1 hub router and 3 spoke routers.


If you don't have sufficient routers available, check out Dynamips. You could set up a virtual Frame Relay network using this software.


Best Regards,


Michael

CSCO10758684 Mon, 01/28/2008 - 09:59
User Badges:

Hai ,


Thanks for the reply ...i have 4 1721 router and one 2800 ...is it possible to make a lab using this ...i ve to check wheather i shud have enough WIC card ....wud be nice if you can pase the Frame-Relay switch config and Hub/Spoke router config ,...


Thanks

Lijesh.N.C

Edison Ortiz Mon, 01/28/2008 - 08:44
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

The following document describes how to configure back-to-back Frame Relay.


http://www.internetworkexpert.com/resources/backtoback-framerelay.htm


And, the following document describes how to build a compound high density Frame Relay switch by cascading multiple routers which have a low density of interfaces


http://www.internetworkexpert.com/resources/compound.frame-relay.htm


HTH,


__


Edison.

CSCO10758684 Mon, 01/28/2008 - 10:04
User Badges:

Hai


Thanks alot Edison .... i think it may take some time for me to arrange this ..setup ..any way i will do this ..thanks a lot onece again


Lijesh.N.C

Actions

This Discussion