VIC-2FXO-M2 - Caller ID, CLID & CME 3.3

Unanswered Question
Jan 28th, 2008
User Badges:

Hi there, been racking my brains trying to get Caller ID working with the VIC-2FXO-M2. Installed in a 1760, have pretty much tried every combination of options in the voice-port 2/1 config (see below pasted section). I can't think what else I need to do get get this working. If anyone can cast any light on the subject matter it would be appreciated. VMT


!

voice-port 2/1

input gain 8

output attenuation -1

no comfort-noise

cptone GB

timing sup-disconnect 85

connection plar opx 3007

impedance complex1

caller-id alerting dsp-pre-allocate

!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Mon, 01/28/2008 - 12:58
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, if you connect an analog phone, does it work ?

Also please state exact IOS you're using.

Bananaskin Mon, 01/28/2008 - 13:05
User Badges:

Sorry, analog phone on the FXO port?

As for the ISO version: 12.3.14T7(ED)

paolo bevilacqua Mon, 01/28/2008 - 13:07
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You connect a phone with clid display to your wall jack and check that clid is displayed.


About IOS, if you ram/flash allows, better would be 12.4(3j).

Bananaskin Mon, 01/28/2008 - 13:26
User Badges:

Sorry, took my eye off the ball. Yes the line does receive CLID information and likewise the GSM gateway sends the CLID info as well. As for 12.4(3j) not enough ram to comfortably run that version.

paolo bevilacqua Mon, 01/28/2008 - 13:38
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Ok, can you try 12.3(8)T11 ?


Actions

This Discussion