01-29-2008 04:04 AM
Hi,
I have two 6509 switches located in two different offices(connected through 40Mbps pipe). And i have to reserve bandwidth of 2Mbps for certain IP range between these offices. how do i accomplish this.
01-29-2008 04:13 AM
Hi
It does depend on your supervisor and PFC level but if you have a PFC3 card then the 6500 provides something called User Based Rate Limiting. See attached link for more details
HTH
Jon
01-29-2008 05:04 AM
hi ,
thanks for the information. the actual requirement is to reserve 2mbps bandwidth for the data between Servers located in the locations. can i achieve this using user based rate limiting.
thanks
k
01-29-2008 05:06 AM
User based rate limiting is a bit of a misleading term actually as it is based on source and/or destination IP address so yes this should fit your requirements.
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide