01-29-2008 07:45 AM - edited 03-05-2019 08:47 PM
Hi,
I have read through the BCMSN Study Guide and Cisco.com product guide on ISR 3825 and that it supports SPAN on both routed and switchports.
I have a NM-16ESW on the 3825 but I hit a brick wall when I tried to SPAN a routed port with error message:
Interface FastEthernet0/8 does not support SPAN
Please, unconfigure it.
Does SPAN actually support routed ports or is it not supported in add-on modules?
my show run int fa0/8:
!
interface FastEthernet0/8
no switchport
ip address 192.168.0.1 255.255.255.0
end
02-04-2008 10:47 AM
You can configure multiple SPAN or RSPAN sessions with separate or overlapping sets of SPAN sources. Both switched and routed ports can be configured as SPAN sources or destination ports
02-04-2008 11:21 AM
Hello,
That sounds good, please can be more clear? In this case, what's gone wrong?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: