01-29-2008 08:40 AM - edited 03-03-2019 08:28 PM
Hello All
By default uc-520 is shipped with US language settings..if I need to setup a different language wich steps should I follow ?
01-29-2008 09:32 AM
These steps:
http://cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmelocal.html
Hope this helps, please rate post if it does!
01-29-2008 11:35 AM
Thank you for your answer !!!
I know this solution..i have to use the cli and with some instructions I can resolve this issue... but I'd like to know id is there a way to do it using the Cisco Configuration Assistant gui....
01-29-2008 01:10 PM
No, only CLI.
Consider, for all advanced CME tasks, only the CLI works, the graphic tools either don't do it, do it poorly, and in any case they prevent you how to properly configure a router at a professional level.
01-30-2008 01:35 AM
Thanks again !!!
I suppose the CLI was the only way...even if during a small course teacher told us we could use either CLI and GUI (and this spunded strange for me)....now I'm sure with your replies I can't do it with GUI.
01-30-2008 01:48 AM
You are welcome.
Please do rate useful posts using the scrollbox below!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: