Problem after command "switch supervisor" on Catalyst 6000

NBouassiba · ‎01-29-2008

after a switch of supervisor I can't reach some server connected the Catalyst 6000. When I set "show ip arp on the msfc" I see the IP-address and the mac-address but I can't ping the machine

The catOs version ist 7.6(10)

cat6009> (enable) sh module

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok

15 1 1 Multilayer Switch Feature WS-F6K-MSFC no ok

2 2 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes standby

16 2 1 Multilayer Switch Feature WS-F6K-MSFC no ok

3 3 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

4 4 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

5 5 16 1000BaseX Ethernet WS-X6516-GBIC no ok

6 6 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok

7 7 48 10/100/1000BaseT Ethernet WS-X6148-GE-TX no ok

8 8 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

9 9 48 10/100/1000BaseT Ethernet WS-X6148-GE-TX no ok

Please Help

glen.grant · ‎01-29-2008

Did you try clearing the cam table and the arp table on the msfc ?

NBouassiba · ‎01-30-2008

Hi,

I have tried out to clear the arp table on the mscf but doesn't help. There are about

6 server are affected.

Thanks

Pavel Bykov · ‎01-30-2008

Are they in the same VLAN?

NBouassiba · ‎01-30-2008

no, they are in different VLAN