Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
702
Views
0
Helpful
1
Replies

QoS on 3550

volk99999
Level 1
Level 1

‎01-29-2008 11:27 PM

Hi!

I have a need to assign priority to some non-VoIP traffic based on IP address for a few ports on my Cat3550, which works at layer2. All other packets should not be dropped. Maybe by deviding the bandwith of link, or by some other manner.

And one more. The same problem on 2611 router's serial port.

Is it possible at all, and if so, how can I do this?

Best regards.

Labels:
0 Helpful
1 Reply 1

owillins
Level 6
Level 6

‎02-04-2008 01:30 PM

You can set layer 2 or layer 3 priority on your data and also you can use route-map and ACL through this you can block or deny the particular host based on the ip address in your device .

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents